EcoAs is a robust, modular wall formwork system for flexibility on residential and commercial construction sites, without a crane. It comes with the long-lasting, all-plastic facing alkus. Formwork for shafts and foundations, swimming pools and light industrial works.
Panel heights 300, 240, 160 and 120 cm, panel widths from 25 to 100 cm; for vertical or horizontal set up
90° inside and outside corners and steplessly adjustable articulated corners from 60° to 180°
Panel 120/80 with alkus facing weighs only 33 kg
Maximum load capacity is 50 kN/m² (German standard DIN 18218, table 3, line 6)
Frames made of closed, high-strength hollow steel profiles
High-quality annealed powder coating with additional priming and cavity sealing
Practical MEVA multi-function profile with welded-in Dywidag nuts
Tie hole with conical steel sleeve, welded in from both sides
3 tie holes per panel height 300 and 240 cm, 2 per panel heights 160 and 120 cm; centred tie holes in horizontal Setup
A push-pull strut can be attached at the panel joint to stabilize the panels when forming foundations
Panel connection with compact MEVA assembly lock: one piece, weighs only 1,5 kg
All-plastic facing alkus, no swelling or shrinking
Easy repair of scratches or drill holes etc. on site with the same polypropylene material
Screwable and nailable without chipping off of top layer
The alkus facing lasts as long as the Frame
The MEVA clamp joins and aligns panels with just a few hammer blows. It provides a safe, stable panel connection, fits anywhere on the frame and is light and easy to handle.
Compensating filler areas is simple: up to 16 cm a filler timber and Uni clamp 11 are the only parts that are needed. Excess forming area is always smaller than 40 cm thanks to the panel size range. Filler areas are thus minimised, allowing optimum adaptation to the building layout.
are attached with flange screws 18 to the multifunction profile.
save parts, reduce effort and save time using the stop end bracket 23/60. You simply fit it, tie the formwork – done!
The focus of MEVA's first collaboration with Austrian company GLS was nature conservation and the construction of two fish passes on the River Traun.
High Park Berlin closes the last building gap on Potsdam Square in Berlin.
Logistische Herausforderung beim Neubau der Rathaus-Galerie in Hagens Innenstadt mit Tiefgarage, Bau und Abriss laufen parallel, Baumaterial und -gerät wird über eine einzige Rampe angefahren, Innenstadtbetrieb bleibt unberührt, auch dank MEVA reibungsloser Baufortschritt und hohe Qualitätsstandards gewährleistet.
Bridge construction with MEVA formwork systems: EcoAs, Mammut, KLK 230, and shoring system MEP.
The MEVA engineers were challenged to provide a static concept, starting with a cost-effective method of pouring the floating ceiling for the conference room.
Contractor Maïa Sonnier S.A. used different MEVA formwork systems and solutions to efficiently handle the various forming challenges when building the tunnel and bridges required for the inner-city rail link in populated area.
Push-pull props R and bracing brackets SRL are used to align and support wall formwork. Push-pull props SRL have left- and right threaded spindles. The brace bracket 250 consist of a push-pull-prop R 250 (190 - 320 cm) and bracing bracket SRL 120 (90 - 150 cm).
MEVA FormSet anchors for single-sided formwork, stop end rail and stop end bracket for slab edges and cantilevering slabs with safety mesh for slab edge fall protection
Heavy-duty support frame for single-sided walls beyond 12 m high. The basic unit fits on any truck. Support frame STB 300, can also be used horizontally.